Select a Category
Build Author HuguesP Views 476
Peristaltic pumps, Automatic Cocktail mixer
This is an automatic cocktail mixer made with 8 small peristaltic pumps. this is driven with the touch screen or over wifi. the controller used is a raspberry pi with a Apache webserver
Build Author Retsaj Views 3047
Large 3D Printer 5ft by 5ft print bed
New ultra large 3D Printer design. I'm calling it the AutoCrafter
Build Author Mark Carew Views 4663
C-Beam XL Nema 23 Actuator
This OpenBuilds C-Beam XL actuator is the backbone of a lot of the awesome builds put together by the OpenBuilds community
Build Author David Hartkop Views 732
Humanitarian Medical Instrument Sterilizer Made from RepRap Parts
Instructions to build an open-source off-grid medical instrument sterilizer that can be used by aid workers in places without reliable electrical power
Build Author Naomi Wu Views 4170
Naomi Wu's Automatic Bartender- BarBot!
This is an automatic bartender- a BarBot, designed to be made with off-the-shelf OpenBuilds, V-slot and low-cost 3D printer parts.
Build Author Rodrigo Gonzalez Views 997
The user will input a selection from a variety of pre-established drinks. The user will not need a glass, since it will be provided in the automation process. This completely eliminates the need for a bartender if an RFID purchase system is implemented.
Build Author mcbuilder22 Views 1536
Automatic spray machine.
Build Author Marshall Peck Views 60375
Voxel OX - Extendable 3D Printer and CNC Platform
An open source 3D printer design with a sturdy V-Slot frame
Build Author Mike Hake Views 1723
Epoxy dispenser, to apply non-conductive epoxy to electronic board.
Epoxy dispenser, 2nd one, first one works great. Uses HMI to allow for operator to pull up files for different jobs. 9 prox sensors, Eot and home on all 3 axis. High quality nema23 motors with intergrated drives from applied motion. Uses programmable router for drives.
Build Author Sonny Lowe Views 19079
MakerSL MSL-5 Cantilevered 3D Printer
This is a simple cantilevered 3D Printer. It is designed around the OB V-Slot linear rails. I am trying to simplify this as much as possible, all rails will be 250mm long and only one will require cutting (it will be cut in half). The printer will use all OB wheels and gantry plates where applicable, all other plates can be either Laser Cut or 3D Printed (files will be provided for both). I am not set on electronic as of yet, but plan to use a single control board...no Arduino/Ramps control.
Build Author Jan Koeppen Views 5302
Touchsensor assembly machine
This is a handy machine to assemble touch sensors into display frame.
Build Author winand Views 11314
YAOP (Yet Another Openbuilds Printer)
Yet Another Openbuilds Printer, my version :-P
Build Author mytechno3d Views 15389
Maximus Evolution (Still another XL 3D Printer )
Maximus Evolution : 380mm x 400mm XL 3D Printer
Build Author mytechno3d Views 9028
Cut To Length Machine
A Cut To Length machine controlled by computer
Build Author north90 Views 9179
OpenSampler: OpenSource autosampler for use in laboratory
An open source autosampler to be used in laboratories for the automated analysis of gas or liquid samples.