Welcome to Our Community

Some features disabled for guests. Register Today.

Gantry Plate and Verticle Table for OX XL 2018-03-09

A verticle table for milling ends of stock for joinery

  1. Brian Beebe

    Brian Beebe Well-Known
    Builder

    Joined:
    Jan 24, 2014
    Messages:
    4
    Likes Received:
    6
    Brian Beebe submitted a new resource:

    Gantry Plate and Verticle Table for OX XL - A verticle table for milling ends of stock for joinery

    Read more about this resource...
     
    GrayUK and Giarc like this.
  2. sharmstr

    sharmstr Veteran
    Builder

    Joined:
    Mar 23, 2018
    Messages:
    94
    Likes Received:
    52
    I've been thinking about this for a bit now. It never occurred to me to use gussets. I was just going to have a permanent vertical board that was mounted under the bed. Yours seems to be a better solution. Hows it been working out for you?
     
  3. Brian Beebe

    Brian Beebe Well-Known
    Builder

    Joined:
    Jan 24, 2014
    Messages:
    4
    Likes Received:
    6
    So far so good but haven’t used it much.
     
    sharmstr likes this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice