Welcome to Our Community

Some features disabled for guests. Register Today.

Yamm (Yet another MiniMill)

Discussion in 'CNC Mills/Routers' started by onefoursix, Dec 29, 2017.

  1. onefoursix

    onefoursix Well-Known
    Builder

    Joined:
    Dec 1, 2017
    Messages:
    2
    Likes Received:
    9
  2. GrayUK

    GrayUK The Secret of Life is ..... Choice!
    Staff Member Moderator Builder

    Joined:
    May 5, 2014
    Messages:
    1,304
    Likes Received:
    407
    That's a good looking job there :D
    Well Done :thumbsup::thumbsup:
    May the chips fly for you. :)
    Gray
     
    Mark Carew likes this.
  3. JAK!

    JAK! New
    Builder

    Joined:
    Jan 9, 2017
    Messages:
    1
    Likes Received:
    0
    Where did you find that mount for your spindle?
     
  4. onefoursix

    onefoursix Well-Known
    Builder

    Joined:
    Dec 1, 2017
    Messages:
    2
    Likes Received:
    9
    It's here: Spindle Carriage
    But note its mounting holes are 70mm so I had some struggle to get it mounted on the MiniMill's z axis plate
     
  5. Mark Carew

    Mark Carew OpenBuilds Team
    Staff Member Moderator Resident Builder Project Maker Builder

    Joined:
    Jun 28, 2013
    Messages:
    2,103
    Likes Received:
    1,377

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice