Welcome to Our Community

Some features disabled for guests. Register Today.

XPro V4 CNC touch plate for Z setup

Discussion in 'Controller Boards' started by John Bigbie, May 8, 2019.

  1. John Bigbie

    Builder

    Joined:
    Jun 6, 2014
    Messages:
    1
    Likes Received:
    0
    I am new to CNC. How do I set up a Z touch plate? For an XPro V4 XBee 1010 CNC router. I have the wiring correct to the XPro board, but do I need special G code? Is there a tutorial for the use?
     
  2. sharmstr

    sharmstr Master
    Moderator Builder

    Joined:
    Mar 23, 2018
    Messages:
    728
    Likes Received:
    397
    Depends on the software. Most have it built in like OpenBuilds Control. What software are you using?
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice