Welcome to Our Community

Some features disabled for guests. Register Today.

WorkLead, no wait, LeadBee, naw... WoodWorker

Discussion in 'CNC Mills/Routers' started by Metalguru, Jan 30, 2019.

  1. Metalguru

    Metalguru Veteran
    Builder

    Joined:
    Dec 29, 2015
    Messages:
    752
    Likes Received:
    545
  2. arcrunner

    arcrunner Well-Known
    Builder

    Joined:
    Jul 19, 2018
    Messages:
    48
    Likes Received:
    37
    I agree that the design of the base leaves a lot to be desired. I was thinking or incorporating a design similar to the Sphinx, and maybe removing the inside set of wheels to accommodate, but I'm not sure if that's giving up too much.
     
  3. Metalguru

    Metalguru Veteran
    Builder

    Joined:
    Dec 29, 2015
    Messages:
    752
    Likes Received:
    545
    #3 Metalguru, Feb 14, 2019
    Last edited: Feb 14, 2019
  4. GeoffH

    GeoffH Journeyman
    Builder

    Joined:
    Mar 11, 2017
    Messages:
    178
    Likes Received:
    106
    Re your comments about cutting corner joints etc, I have an XL build and just cut a slot in the spoiler, see Images
    sorry most of the images don't apply.
     
    Paulo Almeida likes this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice