Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

Slow down workbee travel

Discussion in 'CNC Mills/Routers' started by Barzalou, Apr 4, 2021.

  1. Barzalou

    Barzalou Well-Known
    Builder

    Joined:
    Aug 3, 2018
    Messages:
    65
    Likes Received:
    26
    Hello,

    Could someone tell me how I can slow down the default travel speed of my Blakbox controlled Workbee when it moves in the Y-axis direction? The way things are going, when I move the gantry from one side to the other of the CNC, it studers a few times.

    Thanks
     
    #1 Barzalou, Apr 4, 2021
  2. sharmstr

    sharmstr OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 23, 2018
    Messages:
    2,039
    Likes Received:
    1,434
    Go into grbl settings tab and lower your Y max rate. Its $111
     
    #2 sharmstr, Apr 5, 2021
    Barzalou likes this.
  3. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    14,042
    Likes Received:
    4,123
    #3 Peter Van Der Walt, Apr 5, 2021
    Barzalou likes this.
  4. BKramer

    BKramer New
    Builder

    Joined:
    Nov 16, 2020
    Messages:
    6
    Likes Received:
    5
    Just had this problem, stuttering on Z. Tried all the software solutions and no change. Finally figured out it was positional (it worked on one side of the x travel but not the other) and found a short inside the z stepper cable (from openbuilds). Spliced it out and ordered a new one from Amazon.
    [​IMG]
     
    #4 BKramer, Apr 5, 2021
    Barzalou and Peter Van Der Walt like this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice