Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

Operating depth seems off

Discussion in 'Controller Boards' started by Northern designer, Dec 30, 2021.

  1. Northern designer

    Northern designer New
    Builder

    Joined:
    Feb 11, 2021
    Messages:
    14
    Likes Received:
    3
    Good morning guys,
    I am running an opebuilds1515 setup with er11 router up until a few days ago all was going fine but it all of a sudden seems to be cutting a 1/16th of an inch deeper then target depth, any idea what is going on?
    thanks for the help in advance
     
    #1 Northern designer, Dec 30, 2021
  2. sharmstr

    sharmstr OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 23, 2018
    Messages:
    2,039
    Likes Received:
    1,434
    Check the lock collars on the Z axis. Make sure they havent slipped. Mine has a few times.
     
    #2 sharmstr, Dec 30, 2021
  3. Northern designer

    Northern designer New
    Builder

    Joined:
    Feb 11, 2021
    Messages:
    14
    Likes Received:
    3
    ok will do but would the slipping lock collars not make it shallow not deeper?
     
    #3 Northern designer, Dec 30, 2021

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice