Welcome to Our Community

Some features disabled for guests. Register Today.

MAKERCAM POCKETING ISSUE

Discussion in 'CAM' started by Mitch2312, Oct 30, 2018.

  1. Mitch2312

    Mitch2312 New
    Builder

    Joined:
    Oct 30, 2018
    Messages:
    1
    Likes Received:
    0
    Hi,
    I am fairly new to all this so please accept my apologise if I do not use the correct terminology, but I will try my best to explain my issue.
    I am having difficulty with pocketing the number 0 in Makercam.
    Instead of pocketing between the 2 circles that make up the inner and outer lines for the number 0 it wants to remove the whole contents that would leave me with a hollowed out circle rather than a neat 0.
    Any help with this issue would be greatly appreciated.
    Many thanks
    Mitch
     
  2. Mark Carew

    Mark Carew OpenBuilds Team
    Staff Member Moderator Resident Builder Project Maker Builder

    Joined:
    Jun 28, 2013
    Messages:
    2,187
    Likes Received:
    1,486
  3. Mark Carew

    Mark Carew OpenBuilds Team
    Staff Member Moderator Resident Builder Project Maker Builder

    Joined:
    Jun 28, 2013
    Messages:
    2,187
    Likes Received:
    1,486

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice