Welcome to Our Community

Some features disabled for guests. Register Today.

Fusion 360 Question

Discussion in 'General Talk' started by Michael Cramer, Dec 8, 2020.

  1. Michael Cramer

    Builder

    Joined:
    Dec 4, 2020
    Messages:
    47
    Likes Received:
    17
    I am relatively new to Fusion 360 CAM and had a question. When I made my other programs, they ran fine as far as the actual program, but the only problem is the origin. Some were in the center and others were off to the side in a weird spot. Basically I just want it to start either in the bottom left corner or in the center. How can I set this correctly? I’ve looked on YouTube but didn’t come up with anything. Thanks!
     
    Zgoodz89 likes this.
  2. sharmstr

    sharmstr OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 23, 2018
    Messages:
    1,715
    Likes Received:
    1,169

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice