Hallo OpenBuild People I am searching for some advice to figure how my set-up should be. I am currently buying in stuff to extend my CR8 to be able to print 510x510x~600mm ish. My original plan was to have the print head to move in all three axis, X,Z and Y, så the heated will be fixed at the bottom of the build. but I am lookin on a lot of builds, and all of them have heatbed to move up and down, Z-axis, like this one https://openbuilds.com/builds/c3do.5957/ What are the experience on fixed heat bed with printhead moving in all three axis vs moving heated in Z and print head moving Y and X axis. I would like se other build solutions here is my own starting point.
