Welcome to Our Community

Some features disabled for guests. Register Today.

XPRO V3 Stopped working

Discussion in 'Controller Boards' started by drfirew, Feb 19, 2018.

  1. drfirew

    drfirew New
    Builder

    Joined:
    Dec 13, 2017
    Messages:
    2
    Likes Received:
    0
    Dear All,

    I had XPRO V3 working fine, until this afternoon. I was configuring homing settings and after making necessary changes to grbl config.h file and compiled it in Arduino, I was flushing the .hex file to my XPRO board, when suddenly all the light on the board turned off and I can only see the 5V green LED, and flickering green LED on the USB port on the board.

    The flickering is as if it is being programmed but after waiting for long minutes and minutes, this doesn't stop at all, so this is actually not being programmed.

    Turned all powers off and reconnect all cables and tried to power on the board, but there is only the 5V green LED, this time this is from 24V reaching the board. Other than that no LED of the motors is on, lifeless. Universal GCode sender, connects to the port but grbl information is not replied.

    I am posting this to others too, as I am a bit panicking.

    Help, please.
     
  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    13,753
    Likes Received:
    4,070

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice