Welcome to Our Community

Some features disabled for guests. Register Today.

xPRO V3 Home All Gcode

Discussion in 'Controller Boards' started by orbitronics, Oct 12, 2018.

  1. orbitronics

    Builder

    Joined:
    Oct 12, 2018
    Messages:
    1
    Likes Received:
    0
    Hi!

    I've just finished my Sphinx 55 w/ Xpro V3 build.

    I would like to do the actions that occur when you click 'home all' on the openbuilds driver, i thought it would be G28, but it's not.

    Does anyone know what the Gcode is for that?

    I just want to move to the end stops, then use G92 X0 Y0 Z0 to set that corner as my origin.

    Thanks!
     
  2. DarkPenguin

    DarkPenguin Journeyman
    Builder

    Joined:
    Sep 16, 2017
    Messages:
    35
    Likes Received:
    2
    G28 sends it to home. $H should run homing.
     
    MaryD likes this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice