Welcome to Our Community

Some features disabled for guests. Register Today.

Xpro problem

Discussion in 'CNC Mills/Routers' started by Diamont, Oct 5, 2017.

  1. Diamont

    Diamont New
    Builder

    Joined:
    Oct 5, 2017
    Messages:
    1
    Likes Received:
    0
    I have recently purchased a ooznest cnc ox with xpro controller, it was working perfectly.
    Unfortunately the xpro port broke, due to straining of the wire as it was machining
    I have attached images of the board when it was broken

    had that part of the controller replaced but once revired it wasn't not communicating with the motors as it used to.
    ‎I double checked wires and power
    I have not updated grbl as it communicates with the computer.


    Any ideas how to fix it would be greatly appreciated. As im at a loss as. :(
     

    Attached Files:

  2. cdl1701

    cdl1701 Well-Known
    Builder

    Joined:
    Apr 10, 2017
    Messages:
    8
    Likes Received:
    1
    Did you get this fixed Diamont?
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice