Welcome to Our Community

Some features disabled for guests. Register Today.

X and Y axes perpendicularity

Discussion in 'General Talk' started by John H, Aug 31, 2015.

  1. John H

    John H New
    Builder

    Joined:
    Feb 14, 2014
    Messages:
    4
    Likes Received:
    0
    Is there a secret to keeping the x and y axes perpendicular to one another? When the machine is off they will get out of alignment if bumped.
     
  2. Ronald van Arkel

    Staff Member Resident Builder Builder

    Joined:
    May 7, 2014
    Messages:
    471
    Likes Received:
    239
    Hello John,

    No secret, just adjust your y-axis before a cut or make a mechanical bump where you can push your gantry against. Or, try not to bump against the machine :thumbsup:.

    -Ronaldo_O
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice