Welcome to Our Community

Some features disabled for guests. Register Today.

Torch height control and floating head setup question.

Discussion in 'CAM' started by Weldsmith, May 1, 2018.

  1. Weldsmith

    Weldsmith Well-Known
    Builder

    Joined:
    Nov 20, 2017
    Messages:
    22
    Likes Received:
    17
    Hello all, I am using fusion 360 and Mach 3 on a plasma cutter. I have also purchased a generic THC. I have made a floating head to probe z zero on the work piece. Now I a swimming in information on the web for post processors and Macros to make all of this work. Does anyone have a fusion 360 post processor that incorporates floating head?
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice