Welcome to Our Community

Some features disabled for guests. Register Today.

Tool position setting Part I

Discussion in 'CNC Mills/Routers' started by Tweakie, Jan 28, 2014.

  1. Tweakie

    Tweakie OpenBuilds Team
    Staff Member Moderator Builder

    Joined:
    Jan 18, 2014
    Messages:
    785
    Likes Received:
    308
    Tweakie published a new build:

    Read more about this build...
     
  2. Nick Lancaster

    Nick Lancaster Journeyman
    Builder

    Joined:
    Dec 20, 2013
    Messages:
    60
    Likes Received:
    13
  3. Tweakie

    Tweakie OpenBuilds Team
    Staff Member Moderator Builder

    Joined:
    Jan 18, 2014
    Messages:
    785
    Likes Received:
    308
    A very valid point Nick, you can use whichever system suits you best. :)

    As I said in my introduction "The method used for tool position setting is a matter of personal choice but this is what I do".

    Tweakie.
     
  4. Bobnet

    Bobnet Well-Known
    Builder

    Joined:
    Dec 4, 2013
    Messages:
    12
    Likes Received:
    11
    I have a printed mount for the exact same laser. I've been using it on a tool change design, for calibration.
    Looking forward to part II.
     
  5. Tweakie

    Tweakie OpenBuilds Team
    Staff Member Moderator Builder

    Joined:
    Jan 18, 2014
    Messages:
    785
    Likes Received:
    308

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice