Welcome to Our Community

Some features disabled for guests. Register Today.

Thoughts on steel rail ideas

Discussion in 'CNC Mills/Routers' started by orangezero, Jun 3, 2015.

  1. orangezero

    Builder

    Joined:
    May 15, 2015
    Messages:
    10
    Likes Received:
    0
    I apologize for duplicate posting, but after writing a post I noticed few actually read the section I put it in, while the cnc forum seems busy.

    Basically, I was wanting to know if anyone has tried using v-slot with metal wheels (rm2zz, etc) with a square cold rolled steel rail inserted, or a hot/cold rolled steel angle? Comparing the cost of this to other steel rail ideas, this could be quite a bit less expensive.

    full thread here: http://www.openbuilds.com/threads/steel-v-wheels-need-inexpensive-rail-ideas.1927/

    Thanks
    [ps, I'll try to avoid duplicate posting in future]
     

Share This Page

  • About Us

    The OpenBuilds Team is dedicated helping you to Dream it - Build it - Share it! Collaborate on our forums and be sure to visit the Part Store for all your Maker needs.


    [email protected]

  • Like us on Facebook

  • Support Open Source FairShare Program!

    OpenBuilds FairShare Give Back Program provides resources to Open Source projects, developers and schools around the world. Invest in your future by helping others develop their future.

    Donate to Open Source