Welcome to Our Community

Some features disabled for guests. Register Today.

Sudden problems with GRBL Panel

Discussion in 'Control Software' started by dreiii, Dec 4, 2018 at 9:09 AM.

  1. dreiii

    dreiii New
    Builder

    Joined:
    Jan 10, 2017
    Messages:
    1
    Likes Received:
    0
    Have been using GRBL Panel for a year and have had no real problems. Suddenly when I use the overrides when printing, the Feed + and - control both the feed speed and POWER. Have removed software and downloaded fresh copies. Same problem. Completely reloaded Win10 with factory install. Downloaded GRBL Panel again. Same problem.
    HP Laptop with no mods.
    Win10 1803
    Genuine Uno w/ GRBL 1.1f
    Chinese CNC Shield with TI DRV8825 drivers
    JTech Laser unit on OpenBuilds Acro Frame

    Any ideas or suggestions appreciated.

    Just downloaded UGCS Platform and it does the same thing. Must have hardware problems.


    Dan
     
    #1 dreiii, Dec 4, 2018 at 9:09 AM
    Last edited: Dec 4, 2018 at 9:45 AM

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice