Welcome to Our Community

Some features disabled for guests. Register Today.

Speed of Nema 17 in V-Slot Linear Actuator

Discussion in 'Motors' started by higochumbo, Jun 24, 2016.

  1. higochumbo

    Builder

    Joined:
    Jun 24, 2016
    Messages:
    1
    Likes Received:
    0
    Hello,

    I would like to build my own moving target range for air rifle. Something like that:
    I'm really not an expert, but it seems like a combination of a V-Slot linear actuator bundle and an arduino plus adafruit motor shield should do the job. What speed can I expect from the Nema 17 stepper motor with this configuration. I need to achieve at least 1 m/s. 1,5 m/s would be nice. Is this doable with fx. the big 30tooth pulley?

    Thank you

    Gerrit
     
  2. CameramanTom

    Builder

    Joined:
    Oct 28, 2019
    Messages:
    8
    Likes Received:
    2
    Dug up this old thread searching for the same information.

    Can anyone help?

    I have a similar request to the original poster except I need to build a high speed camera rail. Payload is about 500g. Need to achieve 50cm/second. Acceleration needs to be 0 to 100 asap, deceleration doesnt matter.

    Is this a realist prospect for a nima17 in a vslot mini?

    Thanks for any input
     
  3. Mark Carew

    Mark Carew OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Jun 28, 2013
    Messages:
    2,742
    Likes Received:
    2,407
    I have been working on a cool targeting system that I think would be a lot of fun. I do not have it yet ready to post but I will do what I can to get it posted asap. :thumbsup:
     
    Peter Van Der Walt likes this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice