Welcome to Our Community

Some features disabled for guests. Register Today.

Routing/saw table

Discussion in 'Other Builds' started by ernst, Nov 10, 2014.

  1. ernst

    ernst New
    Builder

    Joined:
    Nov 9, 2014
    Messages:
    1
    Likes Received:
    0
    Hi,

    I want to build a Routing table where I can swap the Router with a circle saw. Both around 2kw.
    I want to build the base with T-slot profile and the moving parts: saw/router highed adjustment, Sliding table and parallel fence with a accuracy of 0.1mm and I was wondering if this is achievable? I like to make it al manual controlled but then I need a liniear encoder for measuring.

    Is there some information available about the strong the system is so I can make a estimation how much rails and wheel are needed.

    Is there some else who already made something like this, or tips.

    Thanks!
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice