Welcome to Our Community

Some features disabled for guests. Register Today.

Probe and autolevel Issue

Discussion in 'Control Software' started by DynamicDesignsEngineering, May 21, 2018.

  1. DynamicDesignsEngineering


    May 17, 2018
    Likes Received:
    OK, Can anyone tell me what Exactly what could cause an alarm 4 - Probe not in expected initial state before starting probe cycle when .....
    I am running grbl 1.1f, and UGS Platform 2.0 nightly build.
    I went through all my settings, and from what I can tell, everything looks ok (which doesn't necessarily mean they are), and the wording of the alarm is very vague, so I am not sure what the issue is. A list of possible causes could help me troubleshoot would help immensely!


Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice