Welcome to Our Community

Some features disabled for guests. Register Today.

Possible to use limit switches for X and Y Axis only on CNC xPro?

Discussion in 'Controller Boards' started by jeffmorris, Jan 23, 2018.

  1. jeffmorris

    jeffmorris Journeyman
    Builder

    Joined:
    Nov 6, 2017
    Messages:
    97
    Likes Received:
    10
    Is it possible to use limit switches for X and Y Axis only on CNC xPro? I couldn't find a place for a limit switch on the Z Axis. I took the engraving motor and Z Axis carriage from a too-small CNC engraving machine as shown at Micro Center - Computers and Electronics. Is it possible to connect normally-closed E-Stop button to the board?
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice