Welcome to Our Community

Some features disabled for guests. Register Today.

Paser State

Discussion in 'CNC Mills/Routers' started by Vern44, Jan 12, 2017.

  1. Vern44

    Vern44 New
    Builder

    Joined:
    Jan 11, 2017
    Messages:
    1
    Likes Received:
    0
    Hi Guys and Girls.
    New to the site and many thanks for that.
    Playing around with GRBL by Zap maker and arduino uno with a cnc shield.
    What I would like to change is $G View Paser state before it loads.
    Need to change the G21 to G20 and the feed rate.
    Can do this after it's loaded but a bit of a pain in the butt
    Have opened the HEX file but not to sure where to look
    And what to do.
    Thanks to all
     

Share This Page