Welcome to Our Community

Some features disabled for guests. Register Today.

OX 1500x1500 Dual Drive

Discussion in 'CNC Mills/Routers' started by vogtmrk, Nov 18, 2014.

  1. vogtmrk

    vogtmrk Well-Known
    Builder

    Joined:
    Oct 23, 2014
    Messages:
    2
    Likes Received:
    3
    vogtmrk published a new build:

    Read more about this build...
     
  2. Josh Mascote

    Josh Mascote Journeyman
    Builder

    Joined:
    Jan 30, 2014
    Messages:
    32
    Likes Received:
    5
    Looking good! I might have to give this one a go.
     
  3. Tinbasher

    Tinbasher Well-Known
    Builder

    Joined:
    Feb 3, 2015
    Messages:
    11
    Likes Received:
    6
    Im new to the forums and I am just in the planning stage of building my first machine, but I like the idea of the quad X axis rails. If you have the room on either side of the acme screw you could build a truss between the upper and lower rails, cross bracing like the lacing on an offroad buggy frame. That would add a ton of rigidity.
     
  4. vogtmrk

    vogtmrk Well-Known
    Builder

    Joined:
    Oct 23, 2014
    Messages:
    2
    Likes Received:
    3
    There is room, and I think it is needed in the center. I am planning on adding this.
     

Share This Page