Welcome to Our Community

Some features disabled for guests. Register Today.

ooznest ox and Cut2d

Discussion in 'CNC Mills/Routers' started by Charles Coetsee, May 6, 2017.

  1. Charles Coetsee


    Sep 22, 2015
    Likes Received:
    Hi i got Cut2d to use with my machine and it seems to work OK most of the time but sometimes it messes up on the cut. like the machine is being held back so it cuts a few cm out. i thought it was the machine getting stuck but ran it twice today and think it might be in the gcode. i am saving the cut paths for GRBL. any one else had this problem ? thank you for your help ive added a pic to show that the problem is consistent so not a problem with the machine i think.

    Attached Files:

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice