Welcome to Our Community

Some features disabled for guests. Register Today.

Newbie with WorkBee /vCarve pro 9

Discussion in 'General Talk' started by Camvec, Feb 8, 2018.

Tags:
  1. Camvec

    Camvec Well-Known
    Builder

    Joined:
    Jan 30, 2018
    Messages:
    17
    Likes Received:
    6
    Hi folks, just a general question...
    I’m lost and need help, I know there are loads out there but need a difinitive answer, I have the new WorkBee 1500mm x 1500mm full kit (currently getting built) with VCarve Pro 9.014, What post processor do I use, what does everyone else use (I’m assuming this generates the code to operate my workbee.
    I’m not the most technical person around here so be gentle. However ask me to make you a sign! That’s no problem. He he

    Cheers in advance :)
    Cam
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice