Welcome to Our Community

Some features disabled for guests. Register Today.

New OX Build Circles not right

Discussion in 'CNC Mills/Routers' started by Gava, May 7, 2015.

  1. Gava

    Gava New
    Builder

    Joined:
    Mar 9, 2015
    Messages:
    2
    Likes Received:
    0
    Hi,

    Just finishing up an OX build and started to do some test cuts to see how it works.

    Did a simple 50mm circle but it doesn't seem right.

    picture below is of a 50mm circle ones 300mm/min feed and other is 600mm/min feed using a 3mm straight bit.

    [​IMG]
     
  2. Slewratesarego

    Slewratesarego Journeyman
    Builder

    Joined:
    Aug 29, 2014
    Messages:
    53
    Likes Received:
    21
    I don't seem to be able to see your picture.
    Going through a similar sort of problem, although my machine is not an OX.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice