Welcome to Our Community

Some features disabled for guests. Register Today.

New install- XPro V3 stepper turning off and on

Discussion in 'Controller Boards' started by Paul4d, Feb 24, 2018.

  1. Paul4d

    Paul4d New
    Builder

    Joined:
    Feb 17, 2015
    Messages:
    6
    Likes Received:
    0
    Building a minimill with Nema 23. Using a multimeter, I found all the correct pairs of wires. Wired it up. Got green lights on two of the steppers but third one is red? All wired the same. after a few seconds, stepper lights/power go off then back on? I disconnected all but one motor and it does the same.

    Powersupply is the 24/ 14.6 Meanwell.
     

    Attached Files:

    #1 Paul4d, Feb 24, 2018
    Last edited: Feb 24, 2018
  2. Paul4d

    Paul4d New
    Builder

    Joined:
    Feb 17, 2015
    Messages:
    6
    Likes Received:
    0
    Got it working. I had wiring incorrect. Thanks to you Bob on the how to wire the OX video.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice