Welcome to Our Community

Some features disabled for guests. Register Today.

Need feedback on CNC USB controller

Discussion in 'General Talk' started by pappydan, Dec 7, 2017.

  1. pappydan

    pappydan Journeyman
    Builder

    Joined:
    Jul 29, 2016
    Messages:
    45
    Likes Received:
    22
    How many of you folks using the Planet CNC usb control board, and are there any quirks with it. Remodeling machine and was planning on using one.I would like to build a jogging keyboard and make some moves without having to have the computer hooked up. Ie this possible with this unit. From what I read the capability is there, but, sometimes I have trouble with the noodle.
     
  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Resident Builder Project Maker Contest Winner! Builder

    Joined:
    Mar 1, 2017
    Messages:
    176
    Likes Received:
    142
  3. marmageek

    marmageek New
    Builder

    Joined:
    Feb 24, 2015
    Messages:
    10
    Likes Received:
    0
    I have the board; however, I am a NOOB so just trying to figure it all out. There IS a JOG jumper and I have seen videos with the keyboard for it; however, I am not sure where to purchase it.
     
  4. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Resident Builder Project Maker Contest Winner! Builder

    Joined:
    Mar 1, 2017
    Messages:
    176
    Likes Received:
    142
    marmageek likes this.

Share This Page