Welcome to Our Community

Some features disabled for guests. Register Today.

Narrowing down my driver and motor solution

Discussion in 'General Talk' started by future_cncist, Mar 22, 2015.

  1. future_cncist

    future_cncist Well-Known
    Builder

    Joined:
    Feb 20, 2015
    Messages:
    21
    Likes Received:
    1
  2. future_cncist

    future_cncist Well-Known
    Builder

    Joined:
    Feb 20, 2015
    Messages:
    21
    Likes Received:
    1
    Here is a nice demo of how slick they perform

     
  3. future_cncist

    future_cncist Well-Known
    Builder

    Joined:
    Feb 20, 2015
    Messages:
    21
    Likes Received:
    1
    Struggling with the decision , but the original Teknic servos I looked at seem to be much quieter .
     
  4. GrayUK

    GrayUK Openbuilds Team Elder
    Staff Member Moderator Builder

    Joined:
    May 5, 2014
    Messages:
    1,433
    Likes Received:
    463
    Make a note of the need for a brake on the Z axis.
    Consider using a standard Stepper motor for this axis.

    Gray
     
  5. future_cncist

    future_cncist Well-Known
    Builder

    Joined:
    Feb 20, 2015
    Messages:
    21
    Likes Received:
    1
    Brake noted but may not be require using rack and linear rail for the Z :) This is going to be a costly build , steppers and lead screws are out of equation .
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice