Welcome to Our Community

Some features disabled for guests. Register Today.

My OX Build Video - Part 3 Added

Discussion in 'CNC Mills/Routers' started by DazTheGas, Apr 21, 2015.

  1. DazTheGas

    DazTheGas Master
    Builder

    Joined:
    Jan 27, 2015
    Messages:
    74
    Likes Received:
    132
    For those interested I am videoing the build of my Ox from where Mark left off.

    I will be using Mach 4 as the controller software and running from an Ethernet motion controller.

    Part 1 is here

    The whole ox will include lots of mods including a touch display built into the atx case.

    Darrin
     
    GrayUK and Knut Bøje like this.
  2. Tweakie

    Tweakie OpenBuilds Team
    Staff Member Moderator Builder

    Joined:
    Jan 18, 2014
    Messages:
    785
    Likes Received:
    308
    Excellent work with the video Daz ( I watched it on your Artsoft post). Keep up the good work my friend. :thumbsup:

    Tweakie.
     
  3. GrayUK

    GrayUK Openbuilds Team
    Staff Member Moderator Builder

    Joined:
    May 5, 2014
    Messages:
    1,354
    Likes Received:
    428
    Very informative.

    Thanks :thumbsup:
    Gray
     
  4. DazTheGas

    DazTheGas Master
    Builder

    Joined:
    Jan 27, 2015
    Messages:
    74
    Likes Received:
    132
    Finally Part 2 finished setting up the Y and Z axis with a slave on the Y axis.

     
    GrayUK likes this.
  5. DazTheGas

    DazTheGas Master
    Builder

    Joined:
    Jan 27, 2015
    Messages:
    74
    Likes Received:
    132
    Part 3 now uploaded on how to setup the limit switches, homing and software limit switches.



    Enjoy
     
    Knut Bøje likes this.
  6. Tweakie

    Tweakie OpenBuilds Team
    Staff Member Moderator Builder

    Joined:
    Jan 18, 2014
    Messages:
    785
    Likes Received:
    308
    Again, excellent work Daz. :thumbsup:

    Tweakie.
     
  7. DazTheGas

    DazTheGas Master
    Builder

    Joined:
    Jan 27, 2015
    Messages:
    74
    Likes Received:
    132
    Should have next ready over the weekend, that squeeling stepper gave up and took a driver with it, so been busy on the replacements.

    DazTheGas
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice