Welcome to Our Community

Some features disabled for guests. Register Today.

Mounting drivers and BOB on gantry rail?

Discussion in 'General Electronics' started by Bradleymillikan, Jun 16, 2016.

  1. Bradleymillikan

    Builder

    Joined:
    Apr 11, 2016
    Messages:
    1
    Likes Received:
    0
    Hi all,

    Just finishing up my ox build and now I'm on to the wiring. This might have been answered before but I don't know where to look for it. I was starting to mount the driver boards and my bob on the back rail of gantry assembly like suggested. I was wondering if this is what everyone else does? Does this set up work well with dust from cutting wood? I would of course mount exposed parts in a box with fan but wouldn't that just pull dust in? What is your experience with this? If you have this setup how well does it work?
     
  2. Steve Fox

    Steve Fox Veteran
    Builder

    Joined:
    Feb 22, 2015
    Messages:
    129
    Likes Received:
    20
    I can't speak for others, but I put all of my electronics in an old PC case.
    I also have a dust collection boot that collects 95% of the dust.
    Before I came up with that, cleanup was a constant problem.

    Steve Fox
     

Share This Page