Welcome to Our Community

Some features disabled for guests. Register Today.

Made a waste board surfacing bit

Discussion in 'General Talk' started by CDUH, Jul 1, 2015.

  1. CDUH

    CDUH Well-Known
    Builder

    Joined:
    Dec 20, 2014
    Messages:
    6
    Likes Received:
    3
    I took a sears 1/2 in rabbiting bit and bored the bearing stump down with a lathe. This allowed the rabbiting bits to be the lowest part. This made an 1 1/2 surfacing bit. It worked very well. Makes a huge mess though. IMAG0083[1].jpg IMAG0084[1].jpg IMAG0085[1].jpg
     
    Mark Carew and GrayUK like this.
  2. Dave Landry

    Builder

    Joined:
    May 3, 2015
    Messages:
    9
    Likes Received:
    0
  3. Tweakie

    Tweakie OpenBuilds Team
    Staff Member Moderator Builder

    Joined:
    Jan 18, 2014
    Messages:
    785
    Likes Received:
    300
    Very neat idea @CDUH Thanks for sharing. :thumbsup:

    Tweakie.
     
  4. Mark Carew

    Mark Carew OpenBuilds Team
    Staff Member Moderator Resident Builder Project Maker Builder

    Joined:
    Jun 28, 2013
    Messages:
    1,949
    Likes Received:
    1,125
    Great idea @CDUH thanks for sharing! :thumbsup:
     

Share This Page

  • About Us

    The OpenBuilds Team is dedicated helping you to Dream it - Build it - Share it! Collaborate on our forums and be sure to visit the Part Store for all your Maker needs.


    [email protected]

  • Like us on Facebook

  • Support Open Source FairShare Program!

    OpenBuilds FairShare Give Back Program provides resources to Open Source projects, developers and schools around the world. Invest in your future by helping others develop their future.

    Donate to Open Source