Welcome to Our Community

Some features disabled for guests. Register Today.

Laser Software

Discussion in 'Control Software' started by Pino Ellul, Feb 24, 2018.

  1. Pino Ellul


    Feb 24, 2018
    Likes Received:
    Hello, I am new to this, I have just bought a new Mini Laser Engraving Machine 40X50CM DIY Logo Cutting 500mW, it was sent to me without instructions, I managed to assemble the unit, but then I realized that it needed software to be able to use it. I have tried to look up the net and see what I could find, and it was like loosing one self in a jungle. I am still lost.....can any one help me get this machine going ??
  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Mar 1, 2017
    Likes Received:
    Anthony Bolgar and MaryD like this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice