Welcome to Our Community

Some features disabled for guests. Register Today.

Is a TinyG an appropriate controller for the OpenBuilds ACRO?

Discussion in 'CNC Mills/Routers' started by Terry Healy, May 21, 2018.

  1. Terry Healy


    May 21, 2018
    Likes Received:
    New here and just getting started. I'm looking at one of the ACRO kits with motors and see that the 'preferred' controller board is out of stock. I had reviewed the TinyG (TinyG) earlier and was wondering if this was an acceptable replacement.

    Are there any significant drawbacks anyone can think of? Anyone out there using this combination?

    Thanks for your help

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice