Welcome to Our Community

Some features disabled for guests. Register Today.

Ideas on how to connect these parts?

Discussion in 'CNC Mills/Routers' started by iH8vols, Feb 8, 2018.

  1. iH8vols

    iH8vols Well-Known
    Builder

    Joined:
    Dec 4, 2016
    Messages:
    23
    Likes Received:
    3
    I've upgraded my Z axis using the same design in the build below. The only thing I can't figure out, it how to attach the router holder to the Z axis assembly. The holes line up to use 2 of the openbuilds 90 degree angles on the top OR bottom, but not both. Any ideas/suggestions on how he may have attached it? I don't see the 90 degree angles on his machine. Builder hasn't been online in a few weeks either. Thanks!

    https://openbuilds.com/builds/beefed-up-and-customized-ox-build.3163/
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice