Welcome to Our Community

Some features disabled for guests. Register Today.

holder for spindle

Discussion in 'CNC Mills/Routers' started by gibson, Jun 30, 2018.

  1. gibson

    gibson Veteran
    Builder

    Joined:
    Jul 5, 2015
    Messages:
    106
    Likes Received:
    8
    working on holder for my routor but not looking so round but little oval any help or is the in my cam software in fusion 360 ...
     
  2. Giarc

    Giarc Master
    Builder

    Joined:
    Jan 24, 2015
    Messages:
    838
    Likes Received:
    398
    You may need to calibrate the steps per mm if you are cutting ovals where you wanted circles. Do a search for calibration in the search bar.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice