Welcome to Our Community

Some features disabled for guests. Register Today.

Hold-down clamps for pegboard?

Discussion in 'CNC Mills/Routers' started by jeffmorris, Jan 26, 2018.

  1. jeffmorris

    jeffmorris Well-Known
    Builder

    Joined:
    Nov 6, 2017
    Messages:
    372
    Likes Received:
    76
    I almost finished building my CNC engraving machine using the Acro system and parts from broken 3D printer and too-small CNC engraving machine. I used pegboard as spoil board. I 3D-printed hold-down clamps that plug into the pegboard but they loosen and the job was ruined. The pegboard is attached to 3/4" thick plywood and I'm not sure about screwing the hold-down clamps to the plywood. Any suggestions?
     

Share This Page

  • About Us

    The OpenBuilds Team is dedicated helping you to Dream it - Build it - Share it! Collaborate on our forums and be sure to visit the Part Store for all your Maker needs.


    [email protected]

  • Follow us on Instagram

  • Like us on Facebook

  • Support Open Source FairShare Program!

    OpenBuilds FairShare Give Back Program provides resources to Open Source projects, developers and schools around the world. Invest in your future by helping others develop their future.

    Donate to Open Source
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice