Welcome to Our Community

Some features disabled for guests. Register Today.

HGR15 rails on 2040 Makerslide

Discussion in 'General Talk' started by jezter6, Jan 4, 2018.

  1. jezter6

    jezter6 Well-Known
    Builder

    Joined:
    Jan 31, 2016
    Messages:
    23
    Likes Received:
    3
    Has anyone done HGR15 style linear rail on the 20mm side of 2040 makerslide? Looking at inventables cad drawings, there should be enough room to fit the 15mm rail on without a problem. According to hiwin diagrams I've seen, the carriage block rides some 4.3mm above where the rail meets extrusion, and the makerslide bump thing appears to be about 2.96mm, so there should be room for carriage travel.

    But before I ordered linear rail, I was hoping to see if anyone's successfully done it already.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice