Welcome to Our Community

Some features disabled for guests. Register Today.

Haxe for Makers (talk)

Discussion in 'General Talk' started by Franco Ponticelli, Jul 13, 2014.

  1. Franco Ponticelli

    Franco Ponticelli Journeyman
    Builder

    Joined:
    Dec 4, 2013
    Messages:
    65
    Likes Received:
    14
    Hello Builders,
    in May I gave a talk about Making (3d printers, cnc ...) and the Haxe language (a very nice general purpose programming language).

    I hope it is of interest to some of you.



    p.s. OpenBuilds cited at 21:12
     
    GrayUK and Mark Carew like this.
  2. Mark Carew

    Mark Carew OpenBuilds Team
    Staff Member Moderator Resident Builder Project Maker Builder

    Joined:
    Jun 28, 2013
    Messages:
    2,184
    Likes Received:
    1,485
    Very nice @Franco Ponticelli thank you for the share and for the shout out to OpenBuilds!:thumbsup:
    Mark
     
    Franco Ponticelli likes this.
  3. GrayUK

    GrayUK Openbuilds Team Elder
    Staff Member Moderator Builder

    Joined:
    May 5, 2014
    Messages:
    1,431
    Likes Received:
    461
    Hey Franco.

    That was good to watch. I learnt a bit as well. :thumbsup:

    Well Done.

    Cheers
    Gray
     
    Franco Ponticelli likes this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice