Welcome to Our Community

Some features disabled for guests. Register Today.

GWizard and Blackbox

Discussion in 'CAM' started by Zeph, Nov 26, 2019.

  1. Zeph

    Zeph New
    Builder

    Joined:
    Jan 24, 2018
    Messages:
    15
    Likes Received:
    2
    I was wondering if anybody has any experience setting up GWizard Editor with the Blackbox for simulation (post file, etc) who's willing to share their setup. I'm running the Sphinx 55 and the GWizard software seems like a pretty good package, but useless if I can't get the setup/simulation correct.

    Thanks in advance!
     
  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Project Maker Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    8,071
    Likes Received:
    2,670
    BlackBox runs Grbl (widely used CNC firmware) so look for documentation related to Grbl+GWizard - will get more search results that BlackBox+GWizard

    Check out

     
  3. Zeph

    Zeph New
    Builder

    Joined:
    Jan 24, 2018
    Messages:
    15
    Likes Received:
    2
    Thanks Peter! Appreciate the tip on searching with grbl
     
    Peter Van Der Walt likes this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice