Welcome to Our Community

Some features disabled for guests. Register Today.

Cutters, Materals, Router RPM, Speeds and feeds - Share your setup

Discussion in 'General Talk' started by matt_o_70, Feb 27, 2016.

  1. matt_o_70

    matt_o_70 New

    Dec 15, 2013
    Likes Received:
    Hi Guys,
    Is there a thread here where anyone has begun to share results with cutters, materials, DOC and S&F? I am assembling a OX to build some parts and am getting close to cutting. It would be nice if users with built machines shared their favorite cutters and machine settings.

    What are people using for chip load calculations - any favorites?

    Edit: Since my original posting i did come across this thread:
    What cutter? | OpenBuilds
    #1 matt_o_70, Feb 27, 2016
    Last edited: Feb 27, 2016
  2. David the swarfer

    David the swarfer OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Aug 6, 2013
    Likes Received:
    if you are using SketchUcam, you can save your tool setups as tool profiles and can post the files here for everyone to enjoy.
    How to do it is in the help under "Exchange Profiles with friends"

    Also, check 'resources' on this forum for various calculators etc

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice