Welcome to Our Community

Some features disabled for guests. Register Today.

converting pantograf to 3axis cnc

Discussion in 'CNC Mills/Routers' started by mm1, Jan 10, 2016.

  1. mm1

    mm1 New

    Jan 10, 2016
    Likes Received:
    Hi all from Croatia !
    its my first post so i hope its in good section .
    would like to get some help and pointing in right direction about my idea ,i would like to convert pantograf for engraving letters in stone into 3 axis cnc machine to do works on stones marble and granit. working x,y table are 150x100cm
    here is what i got . So my questions are what parts do i need and tmp_19855-20160107_111736-1113887699.jpg tmp_19855-20160107_111745-1601921419.jpg tmp_19855-20160107_111727870793648.jpg tmp_19855-20160107_1117552069134844.jpg is there any shop which sell parts needed and approximate cost ,thx !

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice