Welcome to Our Community

Some features disabled for guests. Register Today.

CNC recommendation OX ,X-Carve etc..

Discussion in 'CNC Mills/Routers' started by betaray, Nov 30, 2015.

  1. betaray

    betaray New

    May 3, 2015
    Likes Received:
    I am new to this Forum
    I am looking at one of the OX or a X-Crave in the large formats and I had some questions.
    I would like to use this for Foam, Aluminum, Brass, Wood and Plastics.
    The OX looks like a well build and strong CNC.
    The X-Crave also looks good.
    I have no problems with mechanical building or doing the electronics so I not worries about any of that.
    I know this is kind of a load question(personal preference).
    Would one machine perform better over the other for the use I have stated.
    also do you have any recommendations about the control boards and software.
    I have seen the tinyg and couple of others.
    What about switching materials and the setups needed to change in the software for that.


Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice