Welcome to Our Community

Some features disabled for guests. Register Today.

Beginner needs guidance in finding software for 2000mW laser engraver

Discussion in 'Other Software' started by George In Canton Ohio, Jul 18, 2018.

  1. George In Canton Ohio

    Builder

    Joined:
    Jul 18, 2018
    Messages:
    1
    Likes Received:
    0
    Hello. I am brand new at this. I purchased a Meco 820100 laser engraver off Ebay. It seems similar to a Decaker desktop engraver, but who knows. Anyway, I have had lousy luck trying to figure out their software since it is "written" in cryptic Chinese/English. THe machine powers up, but I can't get the software to work properly.

    Can I use open source software to control this unit? If so, which one is easiest for a beginner? Your thoughts are very much appreciated.

    Kind Regards:
    George
     
  2. Anthony Bolgar

    Builder

    Joined:
    Jan 14, 2016
    Messages:
    340
    Likes Received:
    177
    Do you know what controller it is using? That is the first piece of info we need to know to help you.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice