Welcome to Our Community

Some features disabled for guests. Register Today.

Bed Heater Prblem

Discussion in '3D printers' started by DaveS1990, Jul 23, 2017.

  1. DaveS1990

    DaveS1990 New

    Jul 7, 2017
    Likes Received:
    I recently purchased a 3D Printer from Goodwill and I can't get the Bed to stay up to Temperature.

    The Temperature gets up to about 40 Degrees and the LED on the Board goes out and doesn't come back on. The Setpoint is 70 Degrees.

    I tried to do an Autotune but it Timed Out.

    It looks almost exactly like the Han's Build on this Webpage: (Voxel OX - Extendable 3D Printer and CNC Platform).

    The Marlin Firmware Version is 1.1.0-RC3.

    The Menu Page says it is Jared's Bot. I would like to get some history on this Printer.
    #1 DaveS1990, Jul 23, 2017
    Last edited: Jul 30, 2017

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice