Welcome to Our Community

Some features disabled for guests. Register Today.

Arduino / Openbuilds - Digital Mitre Saw Cutting Stop

Discussion in 'Concepts and Ideas' started by Makerparts, Jan 12, 2016.

  1. Makerparts

    Makerparts Veteran
    Builder

    Joined:
    Nov 22, 2015
    Messages:
    47
    Likes Received:
    38
    I am intested in building a Accurate Mitre saw stop. I have seen commercial products available that are impressive but over 3k like this



    The mechanical setup are pretty straight forward. I need assistance in programing an arduino to handle the control keypad.

    My ultimate goal is to make a accurate tool to cut down v-slot to .1mm accuracy

    any suggestions or tips would be apprecaited.
     
    Franco Ponticelli likes this.
  2. Rick 2.0

    Rick 2.0 OpenBuilds Team
    Staff Member Moderator Resident Builder Builder

    Joined:
    Dec 20, 2013
    Messages:
    1,689
    Likes Received:
    730
    Makerparts likes this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice