Welcome to Our Community

Some features disabled for guests. Register Today.

Arcylic parts

Discussion in 'General Talk' started by autox3d, Dec 2, 2015.

  1. autox3d

    autox3d New
    Builder

    Joined:
    Oct 3, 2015
    Messages:
    61
    Likes Received:
    9
    [​IMG]

    So far so good using 12mm acrylic machined parts.

    Small holes do not machine well on my homemade plywood mill so I enter drill those and finish with the drill press.

    My previous Bosch Profile OX variant is running fine using the same. this time I am prototyping first with acrylic before sending to water jet for aluminum.
     
    Mark Carew likes this.
  2. autox3d

    autox3d New
    Builder

    Joined:
    Oct 3, 2015
    Messages:
    61
    Likes Received:
    9
  3. Mark Carew

    Mark Carew OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Jun 28, 2013
    Messages:
    2,757
    Likes Received:
    2,428
    Looking good @autox3d !:thumbsup: I love the look of the milled acrylic
    Keep up the good work
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice