Welcome to Our Community

Some features disabled for guests. Register Today.

Any known pros or con of using computer SSD?

Discussion in 'CNC Mills/Routers' started by Alan Estes, May 4, 2016.

  1. Alan Estes

    Alan Estes Well-Known
    Builder

    Joined:
    May 1, 2016
    Messages:
    9
    Likes Received:
    2
    Any known pros or cons of using computer SSD in a CNC application?

    Thanx, Alan
     
  2. Ronald van Arkel

    Staff Member Resident Builder Builder

    Joined:
    May 7, 2014
    Messages:
    469
    Likes Received:
    233
    Hello Alan

    Speed of the SSD (IOPS) is not needed, howeven, SSDs are cheap these days and they are less prone to break when there is vibration near the computer. I would go for a SSD over a HDD any time if I would purchase a new storage device.

    -Ronald
     

Share This Page