Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

Anther Newbie Question

Discussion in 'CNC Lathes' started by T619, May 8, 2018.

  1. T619

    T619 New
    Builder

    Joined:
    May 8, 2018
    Messages:
    2
    Likes Received:
    0
    Im doing a Harbor Fright Lathe conversion by adding stepper motors, to make anything a CNC compatible unit i would need:

    Stepper Motors
    Controllers
    Power unit to power the abouce
    Interfacedoard
    Software (Mach 3)

    Right ?

    After hardware install and software, anything else or all in the software now ?
     
    #1 T619, May 8, 2018

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice